Table of Contents
Advertisement
2. Flip the board over so the 7-pin connector is
facing upward.
3. Place the board into the
housing so that it is
seated properly onto the
board retention shelf.
4. Carefully press the
rubber gasket into
the housing/button
assembly starting at
the strain relief.
Slowly continue
pressing the remain-
ing three sides of the
gasket into the hous-
ing/button assembly.
Make sure that the
seal on the gasket is
completely tucked
into the housing/but-
ton assembly.
C
AUTION: Do Not use any instruments to tuck or
remove the gasket from the housing/but-
ton assembly. Doing so can stretch and
damage the seal on the gasket.
19
Shelf
Advertisement
Table of Contents
