Camera Installation - Techpro IP-EL Series User Manual

1.3 Camera Installation

Dome Installation
Step 1
If included please take the installation position map from the accessories bag,
and then paste it on the ceiling or the wall according to your monitoring area
requirements. Draw and then drill holes in the installation surface and then insert
expansion(anchor) bolts in the holes. Secure these bolts firmly.
Step 2
Turn counter clockwise to remove the decoration ring(plastic housing), turn the
pan base to the pedestal to loosen or secure firmly(metal housing) or Use the
inner hex wrench to remove the three enclosure fastening screws and then
remove the dome enclosure(glass enclousure). Adjust the pedestal position
according to the cable exit move(ceiling/side). Pull the cable through the cable
side exit at the installation surface and the pedestal.
(Please skip this step if you are mounting on a ceiling). Line up the screw holes
at the bottom of the pedestal to the expansion bolts in the installation surface.
Put three self-tapping screws to expansion bolts and then secure firmly. Now the
pedestal is on installation surface.
Plastic Housing
Ceiling or Wall
Expansion Bolt
Dome Camera Body
ST3 Self-tapping Screws
Decoration Ring