Havso Carolina 1.1 Instructions Manual page 15

• If the party tent has walls, you need to angle the infrared heater so
that it is at least 10 cm away from the wall of the party tent using the
universal bracket. Tighten the wing screws in the universal bracket to
secure the angle.
• You can choose to put the infrared heater on one of the tubes in the
party tent roof. This would mean that the infrared heater would be at
an angle, but this is not a problem if you tighten the wing screws on
the universal bracket to ensure that the infrared heater is stable and in
place. The infrared heater must be at least 10 cm away from all parts
of the party tent.
Awning:
• You can choose to put your infrared heater in your awning. You can
either attach it to one of the awning arms or on the awning beam aga-
inst the wall. See the example in figure 6.
• Make sure that the awning valance does not hang down onto the inf-
rared heater. Make sure there is a distance of at least 10 cm between
the infrared heater and the awning valance. Se figure 7.
• Depending on where you put the infrared heater, there is a risk that
the awning valance will get closer than 10 cm to the infrared heater
when the awning is being closed. You therefore have to make sure that
the infrared heater has been switched off and has cooled down before
closing the awning.
How to Use
15