Contents And Assembly - Havso Carolina 1.1 Instructions Manual

5. Angle the infrared heater so that the distance between the infrared
heater and the surrounding surfaces/objects is at least 10cm from
every direction. You angle the infrared heater using the adjustment
screws by turning the entire universal bracket with the infrared hea-
ter. See figures 2 and 3.
6. You can bend the back of the universal bracket around the tube/
beam, attaching it securely using the wing screws. When you angle
the heater, make sure that the wing screws are tightened securely
to fix the angle. Put the nylon washers between the wing screw and
the universal bracket to prevent rust. Se figure 1.
7. Connect the power cable to a grounded 230 V power socket. We
recommend using a ground fault circuit interrupter.
8. Pull the cord to switch the infrared heater on and off. See figure 4.

Contents and assembly

13