14
Work clamp initiator
.27
Requirement
When the work clamp is lowered and shortly before lever 5 in the machine arm touches
stop 6, the initiator should switch on (input "3" parameter "601" is positioned at "off").
Fig. 14 - 23
Switch on the machine and press the "TE" key.
Lower the work clamp by pressing the "tacting forwards" key.
TE
With the clamp in this position, press the "TE" key.
In the input mode, select parameter "601", see Chapter 11.03 Parameter input in the
instruction manual.
Select input "3" with the corresponding plus/minus key.
If necessary, enter the access code, see Chapter 11.04.01 Entering the access code in
the instruction manual.
Move cam switch 1 by hand and check the ON/OFF switch position on the display.
Adjust support 2 (screws 3) and cam switch 1 (screws 4) in accordance with the
requirement.
Switch off the machine.
4
6
5
Adjustment
2
2
1
14 - 26