iDevices IDEV0008 Installation & Setup Manual page 2

R E Q U I R E S
• Wi-Fi 2.4 GHz 802.11 b/g/n
®
compatible network
• Router Security Settings
Supported: WPA, WPA2, or None
• Free iDevices Connected App
®
• 120VAC "Line" and "Neutral" wires
in each gang box
• HomeKit requires an iPhone, iPad or
iPod touch with iOS 9.0 or later
• Android 4.3+ devices with
™
Bluetooth ® Smart technology
2
T O O L S N E E D E D
• Philips Screwdriver
• Pliers
• Wire Cutter/Stripper
• Voltage Detector
• Flathead Screwdriver
R AT I N G S
Input: 125-277VAC, 60Hz
Output: 125-277VAC, 60Hz
Resistive: 1800W @ 120-277VAC
Tungsten: 960W @ 120VAC
Tungsten: 1800W @ 277VAC
Motor: 1HP @ 120-277VAC
Ballast: 10A @ 277VAC
• Not intended for critical medical or life support equipment.
• Use caution when using the iDevices Wall Switch to control any appliances which produce heat or
®
mechanical motion, or could create a hazardous condition when operated while unattended.
• The iDevices ® Wall Switch is not user-serviceable. Do not attempt to open the enclosure for any reason.
• The iDevices ® Wall Switch is only for installation with copper or copper-clad wires. Do not install in a
circuit that uses aluminum wires.
• The iDevices Wall Switch must be installed in a manner that conforms to all applicable national,
®
state, and local building codes.
• The iDevices ® Wall Switch is intended for dry, indoor use only.
• Use with branch circuit breaker 20A or less.
RISK OF ELECTRIC SHOCK, SEVERE BURNS, AND FIRE:
!
Electricity is dangerous and can cause personal injury and property damage if handled improperly.
A working knowledge of electrical installation is required to install this product. If you are not
comfortable working with electricity do not attempt to install the iDevices
professional assistance from a qualified electrician.
Your safety is important to us.
® Wall Outlet and seek
3