iDevices IDEV0008 Installation & Setup Manual page 19

STEP 2
Locate the "primary" Switch. Hold "6" until the LED rapidly flashes
blue (5 sec) then release. Next tap "1" to enter pairing mode. The
LED will flash blue slowly.
Next Locate the "secondary" Switch. Repeat the steps above on the
Secondary Switch by holding "6" until the LED rapidly flashes blue
(5 seconds) then release. Next tap "1" to begin the pairing mode.
The LED will flash blue slowly.
The "secondary" Wall Switch will search and pair to the "primary"
switch. The LED on each Wall Switch will rapidly blink green 5 times
and each Wall Switch will beep 5 times to indicate the pairing
process is complete.
36
1
6
37