Advertisement

SKF TMEH 1
OilCheck
Instructions for use

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TMEH 1 and is the answer not in the manual?

Questions and answers

Summary of Contents for SKF TMEH 1

  • Page 1 SKF TMEH 1 OilCheck Instructions for use...
  • Page 2: Table Of Contents

    5. Important information ..... 7 6. Maintenance ......7 SKF TMEH 1...
  • Page 3: Introduction

    The OilCheck detects and measures the dielectric constant of an oil. By comparing the measurements obtained from used and unused oils of the same brand, the SKF OilCheck is able to determine the degree of change in the dielectric constant of the oil. Dielectric change is directly...
  • Page 4: Operating Instructions

    3.2 Cleaning of sensor Remove the unused sample from the sensor cell with a clean rag or tissue. Clean the sensor by using an electro-contact cleaning solution (penetrating, fast-evaporating, non-residue solution). SKF TMEH 1...
  • Page 5: Measuring

    Within the green band the oil is deemed acceptable and within the red area the oil should be changed and checked again after a short running period to ensure no mechanical problems are present. SKF TMEH 1...
  • Page 6: Contamination Effects

    4. Changes in the viscosity of the oil will cause a slow reduction of the dielectric constant which will be difficult to detect. 5. Changes of the acidity will typically reduce the dielectric strength in a detectable manner. SKF TMEH 1...
  • Page 7: Important Information

    Keep the instrument clean and do not allow the instrument to get wet. If the instrument is dropped or hit the device should be re-calibrated to re-check its performance. To replace the battery remove the 2 screws holding the battery cover in place. SKF TMEH 1...
  • Page 8 Although care has been taken to ensure the accuracy of this publication, SKF does not assume any liability for errors or omissions. SKF Maintenance Products ©...

Table of Contents