You can apply a policy to multiple interfaces.
To configure interface PBR:
Step
Enter system
1.
view.
Enter interface
2.
view.
Apply a policy
3.
to the interface.
Displaying and maintaining PBR
Execute display commands in any view and reset commands in user view.
Task
Display PBR policy information.
Display PBR configuration.
Display local PBR configuration and statistics
(in standalone mode).
Display local PBR configuration and statistics
(in IRF mode).
Display interface PBR configuration and
statistics (in standalone mode).
Display interface PBR configuration and
statistics (in IRF mode).
Clear PBR statistics.
PBR configuration examples
Packet type-based local PBR configuration example
Network requirements
As shown in
Configure PBR on Router A to forward all TCP packets to the next hop 1.1.2.2.
Figure 88 Network diagram
Command
system-view
interface interface-type interface-number
ip policy-based-route policy-name
Figure
88, Router B and Router C cannot reach each other.
Remarks
N/A
N/A
By default, no policy is applied to the
interface.
Command
display ip policy-based-route [ policy policy-name ]
display ip policy-based-route setup
display ip policy-based-route local [ slot slot-number ]
display ip policy-based-route local [ chassis
chassis-number slot slot-number ]
display ip policy-based-route interface interface-type
interface-number [ slot slot-number ]
display ip policy-based-route interface interface-type
interface-number [ chassis chassis-number slot
slot-number ]
reset ip policy-based-route statistics [ policy
policy-name ]
384