Zte ZXHN H168NW User Manual page 19

ZXHN H168NW User Manual
wall by using a telephone cord. In this case, the splitter is not
necessary.
Connection Procedures
1. Power off the equipment before connecting all the other
devices.
2. Connect the network cables: Plug the RJ-45 Ethernet cable
connector into the Ethernet interface of the ZXHN H168NW, and
connect the other terminal to the Ethernet adapter of the
customer computers or ports of other network devices.
3. Connect the splitter.
The splitter has three interfaces as described below:
 LINE: Connects the user telephone cable (RJ11 interface).
 MODEM (or VDSL2): Connects the DSL interface of the
ZXHN H168NW.
 PHONE (or TEL): Connects the phone sets.
The installation process is as follows:
1). Connects the line interface of the ZXHN H168NW to the
Modem (or VDSL2) interface of the splitter by using one
RJ-11 telephone cable.
2). Connects the phone set lines to the Phone (or TEL)
interface of the splitter.
3). Connects the user telephone cable port to the LINE
interface of the splitter.
4. Connect the power supply device.
1). Connect one terminal of the power adapter to the power
port of the ZXHN H168NW.
2). Connect the other terminal to the socket on the wall.
3). Switch on the power of the ZXHN H168NW.
12