Mitsubishi Electric WD-73640 Technical Training Manual page 60

DLP HOME CINEMA
®
Manual Geometry Alignment
1. Entering the Manual Geometry Alignment Mode
1. Activate the Service Mode <MENU><2-4-5-7>.
2. From the Service Menu, press the <0> button. The Data Transfer & Geometry Menu will appear.
Type 2 Data Transfer & Geometry Menu <MENU><2-4-5-7><0>
RESTORE ENGINE DATA FROM BACKUP
RESTORE GEOMETRY DATA FROM BACKUP
MANUAL GEOMETRY ALIGNMENT
RESTORE INDEX DELAY
SAVE ENGINE AND GEOMETRY SETTING TO BACKUP
BACKUP AND RESTORE ISF SETTINGS
RED ONLY AND GREEN ONLY
3. Use the <  > buttons to select "MANUAL GEOMETRY ALIGNMENT" <ENTER>. The Manual Geometry
Alignment Pattern will appear.
Manual Geometry Alignment
<MENU><2-4-5-7><0> "MANUAL GEOMETRY ALIGNMENT"<ENTER>
60