Aichi, 446 Japan declares that this product in accordance with Council Directives, 73/23/EEC (Serial No. : series production) and 89/336/EEC. manufactured by Makita Corporation in Japan is in *from 1st Jan. 2001 compliance with the following standards or standard- ized documents,...
Standard bolt High tensile bolt N • m N • m (kgf • cm) (kgf • cm) (816) (816) M12 x 45 M10 x 45 (M10) (612) (612) M10 x 45 M8 x 45 (M12) (408) M8 x 45 (408) (M8) (M10) (204)
ENGLISH Explanation of general view 1 Push button 7 Switch trigger 12 Seconds 2 Battery cartridge 13 Proper fastening torque for 8 Reversing switch lever 3 Charging light 14 Fastening torque 9 A side 4 Battery charger 15 Screw 10 B side 5 Socket 16 Set plate 11 Fastening time...
4. Always cover the battery terminals with the 3. CAUTION — To reduce risk of injury, charge battery cover when the battery cartridge is not only MAKITA type rechargeable batteries. used. Other types of batteries may burst causing 5. Do not short the battery cartridge: personal injury and damage.
Approx. 60 min. CAUTION: • The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer’s batteries. • When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge.
Makita Authorized Service Center. Hold the tool firmly and place the socket over the bolt or nut. Turn the tool on and fasten for the proper fastening time.
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner.
• Fast charger DC1439 • Plastic carrying case...
UK only DOUBLE INSULATION THE ADDITIONAL COMMENT OF ELECTRICAL CONNECTION The tool is double insulated for safety, no earth connection is required. CAUTION: The tool must be connected to a plug having a rated current greater than that of tool. The rated voltage and current appear on the name plate.