Before Using The Remote Control Unit - Denon PMA-30 Owner's Manual

Contents Connections

Before using the remote control unit

The remote control unit has a built-in lithium battery.
Pull out the insulation sheet before use.
o Replacing the battery
1. Loosen the screws of the back cover with a fine crosshead screwdriver
(purchased separately) and remove the back cover.
2. Remove the old battery, then insert a new coin-shaped lithium battery
(CR2025) so that the + symbol engraved on the battery faces upwards.
3. Put the back cover back on and tighten the screws.
CR2025
Front panel Display
Playback Settings
NOTE
0 If the battery should have a leakage, immediately replace and dispose of the
battery. In this case, there is a risk of burn when the liquid comes in contact with
skins or clothes, so a great care should be taken. If the liquid accidentally comes in
contact, wash with tap water and consult a doctor.
0 Remove the battery from the remote control unit if it will not be in use for long
periods.
17
Rear panel
Tips
Remote Index
Appendix