Control Panel Receptacles; Shutting Down The Unit; Automatic Shutdown - Generac Mobile Products MLT6SK Operating Manual

Operation

CONTROL PANEL RECEPTACLES

The control panel is equipped with multiple receptacles
for running accessories or tools from the generator.
Power is supplied to the receptacles any time the engine
is running and the main circuit breaker is switched to the
ON (I) position.
Note: Do not pull more than 1000W from each receptacle
when the lights are on. This will overload the generator
and cause the main circuit breaker to trip. Should the
breaker trip, switch off the lights, remove some of the load
to the receptacles and wait 10 minutes for the bulbs to
cool before turning them back on.
With all of the lights off, the full generator output may be
used with the 240V twist-lock receptacle.

SHUTTING DOWN THE UNIT

Prior to shutting down the unit, check with personnel using power supplied by the unit and let them know the power
is going to be turned off. Make sure the power shut down will not create any hazards by accidentally turning off
equipment that needs to be kept on (pumps, compressors, lights, etc.).
When you have finished using the unit, proceed with shut down as follows:
1. Remove any loads from the receptacles.
2. Switch the individual circuit breakers for each light and each receptacle to the OFF (O) position.
3. Switch the main circuit breaker to the OFF (O) position.
4. Turn the Control Power switch to the OFF (O) position.
CIRCUIT BREAKERS
I
O
MAIN
BREAKER
240V
I
O
Note: For extended storage time, disconnect the battery. For extended storage requirements, refer to the engine
operator's manual.

AUTOMATIC SHUTDOWN

This unit is equipped with a low oil pressure and high coolant temperature automatic shutdown system. This system
will automatically shut off the fuel supply to stop the engine if oil pressure drops too low or the engine exceeds normal
operating temperature. Return the Control Power switch to the
determined the cause of the shutdown.
22
I I
O O
I I
O
O
Figure 14 - Breakers and Control Power Switch
MLT6SM/K-8SK Operating Manual
240V Twist-Lock
Receptacle
Figure 13 - Location of Receptacles
CONTROL POWER SWITCH
STOP
(stop) position to reset the unit after you have
STOP
120V GFCI
Receptacles
00762
15 SEC.
MAX.
00763
17973 G