Safety Symbol Summary - Generac Mobile Products MLT6SK Operating Manual

SAFETY SYMBOL SUMMARY

This equipment has been supplied with numerous safety and operating decals. These decals provide important
operating instructions and warn of dangers and hazards. Replace any missing or hard-to-read decals and use care
when washing or cleaning the unit. Decal placement and part numbers can be found in the online parts manual at
www.generacmobile.com. Below is a summary of the intended meanings for the symbols used on the decals.
Safety alert symbol;
used to alert you
to potential hazards.
Hot surface(s) nearby.
Belt/entanglement
hazard; keep body parts
clear of this area.
Fan hazard; keep body
parts clear of this area.
Crush hazard; keep
body parts clear of
this area.
Wind hazard; do not set
up in wind speeds
greater than 60 mph
> 60 mph
(95 km/h).
Electrical storm hazard.
Asphyxiation hazard;
operate in well venti-
lated area.
Dangerous voltage may
be present.
Burn/scald hazard;
pressurized steam.
Ultraviolet radiation
hazard; operate only
with lens intact.
17973 G
Do not operate unit
indoors or in an area
with poor ventilation.
Align marks for stowed
position.
Check diesel fuel fill
D
level.
Check engine oil fill
level.
Check coolant fill level.
Read and understand
the operator's manual
before operating.
Allow lamp to cool.
Wait 15 minutes.
15 MIN
Do not step on this
surface.
Do not operate near
powerlines. Contact with
powerlines can cause
electrocution.
Do not remove guard.
Fire/explosion hazard;
keep open flames
away from unit.
MLT6SM/K-8SK Operating Manual
Circuit breaker.
Mast lights.
Glow plugs.
Stop engine.
STOP
Run engine.
Engine start.
Disconnect battery
before servicing.
Unit electrical ground.
Anchor/tie down point.
Forklift here only.
Lift here only.
Safety
00750
5