Prestart Checklist - Generac Mobile Products MLT6SK Operating Manual

PRESTART CHECKLIST

Before starting the unit, all items in the prestart checklist must be completed.
 Read and understand ALL safety sections at the beginning of this manual.
 Ensure all maintenance procedures are up to date. For more information, refer to
Maintenance" on page 27
 The unit must be level with jacks firmly in contact with the ground and wheels lifted approximately 1
inch (2.5 cm) off the ground.
 The unit must be dry. Check for any water inside, on, or near the unit; dry if needed.
 For grounding requirements, follow any local, state or National Electrical Code (NEC) guidelines.
 Switch the Control Power switch to the OFF (O) position.
 Switch all circuit breakers to the OFF (O) position.
 Inspect all electrical cords; repair or replace any that are cut, worn, or bare.
 Ensure all winch cables are in good condition and centered on each pulley. Do not use if cables are
kinked or beginning to unravel.
 Check oil, coolant, and fuel levels. For more information, refer to
Mitsubishi Engine" on page
 Ensure battery connections are secure.
 Check the engine fan belt tension and condition.
 Check the engine fan belt guard.
 Check the engine exhaust system for loose or rusted components.
 Ensure the enclosure is secure.
17973 G
and Basic Maintenance Schedules beginning on
28.
MLT6SM/K-8SK Operating Manual
General Information
"General
page 28.
"Basic Maintenance Schedule -
15