Tuning to radio stations
Press SOURCE on the unit repeatedly or
press TUNER on the remote control
repeatedly until the desired waveband
(TUNER FM or TUNER AM) is displayed.
Press and hold 4 or ¢ for more than
a half second, then release.
The unit automatically tunes to the next
station with sufﬁcient signal strength.
= lights up when receiving a stereo
signal (in FM waveband only).
Repeat step 2 until you ﬁnd the desired
To tune to a station with a weak signal
press 4 or ¢ brieﬂy, and repeatedly,
until an optimal reception is found.
Storing radio stations
You can store up to 40 radio stations in the
memory, starting from FM and followed by
AM wavebands. Stations can be stored
automatically or manually, or by using the
"Plug and Play" function. If no button is
pressed within 20 seconds the unit will exit
from the storing mode.
Storing by using "Plug and Play"
You can store all available radio stations
automatically. Attention:All previously
stored radio stations will be replaced.
Connect the unit to the power supply.
TUNER and AUTO INSTALL - PRESS
PLAY are displayed.
In standby mode, press and hold É Å on
the unit until TUNER and AUTO INSTALL
PRESS PLAY are displayed.
Press É Å on the unit to start the
TUNER INSTALL is displayed and
automatic search and store process
During search TUNER AUTO is displayed.
As soon as a radio station is found and
stored the frequency and the waveband
will be displayed.
Once completed, the last tuned radio
station will be played.
Note: If no stereo signal is detected CHECK
ANTENNA is displayed.