Table of Contents
Advertisement
Installations
Unpacking
Sapphire III (Base) has completed all the QC tests before leaving factory. Please open the packing carefully and
check if there is any damage caused during transportation process. If any, please contact the carrier immediately.
We strongly recommend you to keep the packing materials in case of potential transportation. In order to avoid
damages, please do not use other alterative packing materials to transport the apparatus.
Box shook contains following attachments:
• 1 x Sapphire III(Base).
• 2 x Rack ears (w/ 6 screws).
• 1 x Power cord.
• 1 x Owner's manual.
• 1 x Warranty card.
Caution:
Please read all the safety instructions in
this manual carefully before installation.
Setting up the apparatus
Please prepare the following materials before installation (Not provided):
• Input cable.
• Output cable.
• Straight screwdriver.
• Philips (Cross-type) screwdriver.
• Rack or cabinet to install the amplifier.
• Cat-5 shielded twisted pair.
Dimensions of Sapphire III (Base): Height: 44.5mm; width: 483mm; depth: 301mm.
Please use a standard 19 inch (483mm) rack to mount the amp. A single amplifier can be installed on a solid surface.
Multiple can be installed using stack installation.
Attention:
Fixed installation must be installed in the front and rear side of the amplifier.
Vertical space between amplifiers should be larger than 10mm as shown below.
Space between amplifiers
Caution:
Any unauthorized changes or modifications can void user's right of receiving warranty.
Sapphire III（Base）Power Amplifier
should be ≥10mm
Manual
Sapphire III(Base)
Acessories box contains:
● 2 x Rack ears (w/ six screws).
● 1 x power cord.
Warranty card
11
Advertisement
Table of Contents
