Stereo Channels 17/18 - LD LDVIBZ24DC User Manual

39
40
41
42
43
44
45
46
10
STEREO CHANNELS 17/18 AND 19/20
39
MIC CHANNEL 17/18 AND 19/20
Balanced inputs of the channels 17/18 and 19/20 with 3-pin XLR sockets for connecting microphones.
Channels 17/18 and 19/20 can be used as both mono and stereo channels, depending on the incoming
signal (XLR and jack L IN = Mono / jack L and R IN = Stereo). A 48 V phantom power supply is available for
operating condenser microphones, and it can be switched centrally to the XLR sockets (N° 3). Please set the
Gain controller (N 41) to minimum (left stop) before connecting or disconnecting a microphone; and switch
on the phantom power only after connecting the microphone, or off before disconnecting.
40
LINE IN L/R CHANNEL 17/18 AND 19/20
Unbalanced inputs for the stereo channels 17/18 and 19/20 with 6.3 mm jacks to connect external devices
with line level (e.g. keyboard). If only the left input jack is used (L), the channel will be mono.
40
LINE IN L/R CHANNEL 17/18 AND 19/20
Unbalanced inputs for the stereo channels 17/18 and 19/20 with 6.3 mm jacks to connect external devices
with line level (e.g. keyboard). If only the left input jack is used (L), the channel will be mono.
41
GAIN CHANNEL 17/18 AND 19/20
Adjusting the gain of the microphone input from 0 to 50 dB, or the sensitivity of the line input from +15 dBu
to -35 dBu. Adjust the Gain controller so that the Clip LED of the corresponding channel only lights up briefly
when signal peaks occur. Avoid the permanent lighting of the Clip LED by reducing the input gain or input
sensitivity; if necessary, reduce the volume of the external audio device.
42
EQUALIZER HI CHANNEL 17/18 AND 19/20
Equalizer high band for channels 17/18 and 19/20 (12 kHz, +/-15 dB). When turned to the left, levels are
lowered, when turned to the right, they are raised. In the centre position (resting point), the equalizer is
inactive.
43
EQUALIZER MID HI CHANNEL 17/18 AND 19/20
Equalizer mid band HI for channels 17/18 and 19/20 (3 kHz, +/-15 dB). When turned to the left, the high mid
levels are lowered, when turned to the right, they are raised. In the centre position (resting point), the equalizer
is inactive.
44
EQUALIZER MID LOW CHANNEL 17/18 AND 19/20
Equalizer mid band LOW for channels 17/18 and 19/20 (500 Hz, +/-15 dB). When turned to the left, the Low
mid levels are lowered, when turned to the right, they are raised. In the centre position (resting point), the
equalizer is inactive.
45
EQUALIZER LOW CHANNEL 17/18 AND 19/20
Equalizer bass band for channels 17/18 and 19/20 (80 Hz, +/-15 dB). When turned to the left, levels are low-
ered, when turned to the right, they are raised. In the centre position (resting point), the equalizer is inactive.
46
EQ ON / OFF CHANNEL 17/18 AND 19/20
Switch for switching the equalizer (HI, MID HI, MID LOW and LOW) on and off. In the down position, the
equalizer is enabled, and in the up position, it is disabled.
47
AUX 1 + AUX 2 CHANNEL 17/18 AND 19/20
Volume controller for adding the signal from channel 17/18 and 19/20 to external effects devices (Effect Send,
switch N° 48 POST), or for controlling active stage monitors (Monitor Send, switch N° 48 PRE) Use the line
outputs AUX SEND and 2 control (N 12) for control.