If Problems Occur - FOR-A DCC-100 Operation Manual

6. If Problems Occur

If any of the following problems occur during operation of your unit, proceed as indicated below to
see if problem can be corrected before assuming a unit malfunction has occurred.
Problem
Cannot operate
front panel.
Cannot make
GAMMA MODE
setting by
dipswitch.
Input video signal
not bypassed when
powered OFF.
No split screen is
displayed.
No split screen is
displayed despite in
SPLIT mode.
(Composite out)
No split screen is
displayed despite in
SPLIT mode.
(SD-SDI out)
Check
With DCC-OU
With DCC-OUA
With DCC-OU
With DCC-OUA
VIDEO OUT connection
(rear panel)
SPLIT mode setting
(front panel)
SPLIT OFF setting
(dipswitch)
SPLIT OFF setting
(dipswitch)
If dipswitch SW2-1 is set to DCC-OUA(ON),
change to DCC-OU (OFF). See section 5-1-2.
"SW2."
INPUT SELECT and SPLIT cannot be set
from DCC-100 front panel. Set them from
DCC-OUA.
If dipswitch SW2-1 is set to DCC-OUA(ON),
change to DCC-OU (OFF). See section 5-1-2.
"SW2."
GAMMA MODE cannot be set from the
dipswitch on DCC-100. Set it from DCC-OUA.
Only SD-SDI OUT 1 and COMPOSITE OUT 1
have bypass capability.
See section 2-2. "Rear Panel."
If SPLIT switch is set to OFF, change split
mode to 1 or 2. See section 4-2-2. "SPLIT
If SW1-3 is set to SPLIT OFF, change to
SPLIT ON. See section 5-1-1. "SW1."
If SW1-4 is set to SPLIT OFF, change to
SPLIT ON. See section 5-1-1. "SW1."
15
Action