Debug Command; Debug Messages - ProCurve 2910al-24g Management And Configuration Manual

N o t e

Debug Command

At the manager level, use the debug command to perform two main functions:
■ Specifies the types of event messages to be sent to an external destination.
Specifies the destinations to which selected message types are sent.
■
By default, no debug destination is enabled and only Event Log messages are
enabled to be sent.
To configure a Syslog server, use the logging <syslog-ip-addr> command. For
more information, see "Configuring a Syslog Server" on page C-53.

Debug Messages

Use the debug command to configure the types of debug messages that the
switch can send to configured debug destinations.
Syntax: [no] debug < debug-type >
acl
When a match occurs on an ACL "deny" Access Control
Entry (with log configured), the switch sends an ACL
message to configured debug destinations. For more infor­
mation, refer to the "Access Control Lists" chapter in the
Advanced Traffic Management Guide. (Default: Disabled -
ACL messages for traffic that matches "deny" entries are
not sent.)
all
Configures the switch to send all debug message types (ACL,
Event Log, IP RIP, and LLDP) to configured debug destina­
tion(s). (Default: Disabled - No debug messages are sent.)
event
Configures the switch to send Event Log messages to config­
ured debug destinations.
Note: This value does not affect the reception of event
notification messages in the Event Log on the switch.
Troubleshooting
Debug/Syslog Operation
C-49