Cli: Modifying The Interface Access - ProCurve 2910al-24g Management And Configuration Manual

Interface Access
Enable/Disable
Console Control
Options
Figure 7-2. Listing of Show Console Command
4. When you have finished making changes to the above parameters, press
, then press
[Enter]

CLI: Modifying the Interface Access

Interface Access Commands Used in This Section
show console
[no] telnet-server
[no] web-management
console
Listing the Current Console/Serial Link Configuration. This
command lists the current interface access parameter settings.
Syntax: show console
This example shows the switch's default console/serial configuration.
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax: [no] telnet-server
To disable inbound Telnet access:
ProCurve(config)# no telnet-server
To re-enable inbound Telnet access:
Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
(for Save).
[S]
below
below
page 7-7
page 7-7
Event Log Event
Types To List
7-5