Mileage Counter - At$Mc - Daviscomms MTD2000 Command Manual

Note: Write setting.
AT$MS?
Note: Query setting.
Parameters
Mode 0 – Disable mileage counter (pulse counting)
1 – Enable mileage counter (pulse counting)
Default is 0 (Disable)
Initial Initial odometer reading in km (0 to 800,000 km)
Default is 0 km.
Pulse Number of pulses that equivalent to 1 km (100 to 5000 pulses)
Default is 100 pulses.
Example
Command
AT$MS=1,10,200
Note: Set odometer reading.
AT$MS?
Note: Query odometer setting.
16.5 Mileage Counter – AT$MC
This command allows user to set odometer threshold for monitoring. When the odometer
reading is equal to the preset threshold, the mileage counter flag in the event table will be set.
Note:
The current odometer reading is saved and will not be reset when the power of the device is
cycled.
Syntax
Command
AT$MC=<Mode>[,<Threshold>]
Note: Write setting.
Confidential
$MS: <Mode>,<Initial>,<Pulse>
OK
$MS: 1,10,200
DAVISCOMMS (S) PTE LTD
MTD2000 AT Command Guide R12
Response
Response
OK
64 /105