Table of Contents
Advertisement
FUNCTIONAL SPECIFICATION
PTZ Controller
■
How to connect each terminal and LCD screen
PTZ Operation Test: Performs basic operational PTZ movements;
Up, Down, Left, Right, Zoom, and Manual Focus. It also tests
various protocols and their transmission speeds. In order to control
a PTZ, connect the PTZ communications cables to TX terminals of
the Rapport III.
- PTZ Control
Setup
Screen
DATA
Pressing this button
displays the received PTZ data.
ADD Setup Screen
Protocol Setup Screen
- Keyboard Controller Code Screen.
- The controlling protocol from the
keyboard or the DVR is displayed
on this screen. More important,
however is that the communications
speeds are matched.
Communications
Speed Setup Screen
38
FUNCTIONAL SPECIFICATION
■
How to Control a PTZ Camera
PTZ functions - Up, Down, Left, Right movements are carried out using the
SETUP Buttons. Focus and Zoom adjustments are made using the
FAR/NEAR (Focus) and TELE/WIDE (Zoom) buttons.
■
Function Setup of the PTZ
Use the SETUP keys to adjust GPST / SPST / FUNC / SPD and
MENU settings (displayed on the lower part of the LCD screen)
by pressing the SET key once.
GPST (GO TO PRESET): Moves the camera view to a designated preset
location; Presets are numbered 000 to 255. The cursor moves to the GPST
position when the
key is pressed. Select the previously stored PRESET
number using the
keys (move by+1, -1 step). Once selection is
complete, press the
key once more and the camera will move to the
PRESET location.
SPST (SET PRESET): Sets and stores PRESET information in the range from
000 to 255. First, move the camera to the required view and press the
key, and use the
keys to place the cursor at the location of the
chosen preset. Then set up the address where the preset is to be stored by
using the
keys, and press the
The location information is now stored as a preset address.
FUNC: Follows the FUNC set up using the SPST and MENU information. The
Setup range is from 00 to 63. It can be set by +1,-1 step by using the
keys.
SPD (SPEED): Move the cursor to the SPD icon, using the procedures
described above. A total of 16 increments in speed (1 to 16) are available for
selection using the
MENU : Place the cursor at the MENU location, using the procedures described
above. The MENU of the PTZ can be displayed on LCD screen, using the
key.
* When set the above functions, it can be set by +10, -10 steps by using the
keys.
key once more.
keys.
39
Advertisement
Table of Contents
