Digital Multimeter - Eneo Rapport III Instruction Manual

FUNCTIONAL SPECIFICATION
WARNING
1. DO NOT unplug the SD card during recording.
2. Stop recording or playback before powering off the system.
3. DO NOT use the DVR function when there's a Low Battery warning.

Digital Multimeter

Voltage, resistance and continuity can be tested.
WARNING
To prevent electric shocks, injury, or damage to the Rapport III,
disconnect the power supply to the circuit under test, and discharge all
high-voltage capacitors before testing resistance and continuity.
When using the meter function of the Rapport III, make sure the unit is
switched on and set to the appropriate test mode before connecting
the test lead set to the circuit under test.
■
Setup Keys
Press the button to measure resistance; pressing the
button changes from the OHM scale to BUZZER (for continuity
testing).
Press the button to measure voltage; pressing the
button causes the measurement range to toggle between ACV and
DCV.
34
FUNCTIONAL SPECIFICATION
■
Description of Meter Function LCD Window
Part Function
- Resistance Test
Type of Test Set - Continuity Test
À
- DC and AC Voltage
Up
- Unit of resistance Test
Test value - Indicates either the AC or DC Voltage Range
Á
Displayed - AC Voltage is indicated as RMS (Root Mean
Square) Values
- The Measured Input value is Displayed in the
Form of a Graph
Measured Graph
- The Graph is Changed Automatically and is
Â
Value Equal to the Measured Value
- OVER is Displayed When the Measured
Value is Higher Than the Setup Value
Measured Value The Measured Value is Stored and Displayed
Ã
on Hold Here When the SET Key is pressed
Ä MODE Display Digital Multimeter Mode is displayed
DC DC Voltage Test
AC AC Voltage Test
Resistance Test (Measuring Unit: Ω)
OHM
Å
VOLT Voltage Test (Measuring Unit: V)
Continuity Test (Starts to beep when below
BUZZ
80Ω)
Description
35