Controls And Display; Turning Your Device On/Off - Hover-1 CRUZE Operation Manual

CONTROLS AND DISPLAY

PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY

TURNING YOUR DEVICE ON/OFF

Power ON: Take your device out of the box and place it flat on the
floor. Press the power switch (located on the right of your device)
once. Check the LED indicator (located in the center of your device).
The battery indicator light should be lit, indicating the device is
powered on.
Power OFF: Press the power switch once in the OFF position.
SENSOR
There is one foot pad sensor on the rear of your skateboard, indicated
by the dot pattern. Once the Cruze is manually set in motion, cruise
control is activated when the user steps and holds their foot on the
sensor.
BATTERY INDICATOR
The display board is located in the middle of the Cruze.
The green LED light indicates battery levels of 20%, 50%, 75%, and
100% respectively. Please refer to the diagram below. When the
battery level is low, the LED light will flash, indicating the device should
be charged.
Battery Indicator
7
Mode Indicator Light
Mode Button