Boiler Set-Up; General; Wall Mounting; Floor Standing Installation - PeerlessBoilers Peerless PureFire PFC-460 Installation, Operation & Maintenance Manual

2. BOILER SET-UP

A. GENERAL
1. P F ® boilers are intended for installation in an
URE IRE
area with a floor drain or in a suitable drain pan.
Do not install any boiler where leaks or relief valve
discharge will cause property damage.
2. The P F ® boiler is not intended to support
URE IRE
external piping. All venting and other piping should
be supported independently of the boiler.
3. Install the boiler level to prevent condensate from
backing up inside the boiler.
CAUTION
This boiler must be installed level to prevent
condensate from backing up inside the boiler.
4. P F ® boilers can be wall mounted or floor
URE IRE
standing. The following instructions provide guidance
for both configurations.
B. WALL MOUNTING
The PFC-460 boiler can be wall mounted by using the
optional stand (91400).
1. Use the leveling feet provide with the boiler to assure
proper level.
2. Be sure to leave adequate provisions for condensate
piping and/or a pump (if required).
C. FLOOR STANDING INSTALLATION
1. For floor standing installations, use the leveling feet to
assure that the boiler is completely level. This will
prevent condensate from backing up in the boiler.
2. Be sure to leave adequate space for condensate
piping or a pump if required.
BOILER SET-UP
7