Electrolux EWC 1350 User Manual page 22

22 www.electrolux.com
13.2 Unpacking
When supplied the washing machine is
packed using a number of locking
devices/packing pieces to prevent drum
and motor from damage in transit All
transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit
devices so that they can be refitted if the
machine ever has to be transported
again.
1. Spread some of the polystyrene
packaging materials on the floor
behind the machine and then lay the
machine carefully rear side down on
them. Make sure that no hoses are
crushed in the process.
2. Remove the polystyrene base from
the bottom of the appliance.
3. Return machine to it's upright
position and remove the power
supply cable and the draining and
inlet hose from the hose holders on
the rear of the appliance.
4. With a suitable spanner unscrew and
remove the three screws and their
spacers on machine's rear.
5. The three holes must then be
plugged with the plastic plug caps
supplied in the bag containing the
instruction booklet, which can be
found inside the drum.
13.3 Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or furniture. Level the
washing machine by raising or lowering
the two front feet. If necessary, check the
setting with a spirit level. Any necessary
adjustment can be made with a spanner.
Accurate levelling prevents vibration,
noise and displacement of the machine
during operation.