Table of Contents
Advertisement
AXIS A4011-E Reader
Identification Types
Identification types are portable credential storage devices, pieces of memorized information, or
various combinations of the two that determine how users will be granted access to the door.
Common identification types include tokens such as cards or key fobs, personal identification
numbers (PINs), and request to exit (REX) devices.
The reader supports the following formats:
•
MIFARE® DESFire®
•
MIFARE® Classic
•
iClass®
To program the reader for MIFARE®Classic sector reading, a customer-specific setup card is needed.
For more information, contact Axis Support at www.axis.com/techsup.
Power & Data Connector
4-pin terminal block for DC power input and data. Supports RS485 and
OSDP protocols for communication with the door controller.
NO TICE
TICE
NO
NO
TICE
Use a Safety Extra Low Voltage (SELV) compliant limited power source (LPS) with either
a rated output power limited to≤100 W or a rated output current limited to ≤5 A. For
example, AXIS A1001 Network Door Controller fulfills these requirements when powered
by Power over Ethernet (PoE) or a SELV-compliant LPS.
Function
Pin
1
DC input
2
0 V DC (-)
3
RS485
4
Important
• The recommended maximum cable length is 30 m (98.4 ft).
• To use the reader with AXIS A1001, connect the RS485 wires from A to B and from B to A.
For more information about Axis network door controller connections, see the hardware
pin chart, generated through the door controller's hardware configuration, and the User
Manual, available at www.axis.com.
Notes
Power input from controller or
external power supply. Note: This
pin can only be used as power in.
For half duplex RS485 (RX/TX)
8
Specifications
Min 12 V DC (-10%)
Max 24 V DC (+15%)
A
B
Advertisement
Table of Contents
