Chapter 2 - Getting Started; Notes Before Use - Aaeon RTC-700M User Manual

2.2 Notes Before Use

Before using your device, please read through the following instructions
Use only the power adapter that comes with your device. Using a different
power adapter may cause damage.
Before plug the AC adapter to the device, please make sure the power is
stable and in case unwanted APPs open randomly or the screen is
flickering, please close it manually.
The AC cable is designed for the RTC-700M only
This product is intended to be supplied by a Listed Power Adapter or DC
power source, rated 12Vdc, 3A minimum, Tma = 40°C. Please contact
AAEON for further assistance.
Using a power outlet is the best way to charge your device (refer to section
1.2 for the adapter's voltage output and acceptable input)
When using the device for the first time, fully charge the battery for up to 8
hours. If the device is inactive, charging the battery once per month is
recommended to prevent deterioration.
There are two batteries in the RTC-700M: Battery 1 is internal while battery
2 is swappable by the user (both batteries can be monitored at the title bar).
Charge the device once battery 1 drops below 20%
Always allow your battery to be fully charged before use. Calibrating the
battery before use is also highly recommended.
To prolong battery life, allow a fully charged battery to discharge more than
95% before recharging
Ensure that the battery cover is properly secured by manually pushing the
pin to lock position.
The RTC-700M CANNOT be charged via an USB connection.
The IP65 waterproof protection may get damaged when subjected to
shocks greater than levels tested in MIL-STD-810G Method 516.6
Chapter 2 – Getting Started 10