Porter-Cable 7812 Instruction Manual page 5

WARNING:
until you have read and understood this entire instruction manual.
Release the two container locks (A), Fig. 1, (one on each side of Vacuum
Cleaner), by pulling outward on the bottom of each lock.
Lift the Motor Unit from the container and carefully set aside.
Remove the wheels and accessories from the container.
Fig. 1
CAUTION: DISCONNECT APPLIANCE FROM POWER SOURCE.
For model 7814, begin with instruction #5.
1. Invert the container on a solid, flat surface (like a workbench or floor).
2. Install the two Steering Rollers into the holes provided in the bottom of
the container. Seat firmly.
3. Insert the wand rest, (A) Fig. 2 into its position and seat firmly.
4. The wheel and axle assembly consists of two wheels on an axle. Place
this assembly in the slot provided in the bottom of the container, and press
into place. Seat firmly.
5. Set container upright, on its wheels.
NOTE: If the Vacuum Cleaner is to be used to pick-up liquid or wet
material, skip step 6.
6. Install the paper filter bag. Please note that the mounting hole is offset in
the bag. The hole is closest to the top side of the bag. Position the bag (into
the container), with its top side up, and seat mounting hole onto the
container's intake port. NOTE: Press only on the bag's protective card. Be
careful to not tear the bag.
7. Place the motor unit onto the container and secure it by closing the two
container Locks.
Do not connect the appliance to the power source
A
A
ASSEMBLY
5
Fig. 2