Technical Specifications; Operating Instructions; Employer's Responsibilities; Power Source - Porter-Cable NS100A Instruction Manual

Narrow crown stapler

Hide thumbs Also See for NS100A:

Instruction manual (11 pages)

Table Of Contents

Table of Contents

Available languages

Noise level

. . . . . . . . . . . . . . . . . . . . .

A - Weighted sound impulse

power level . . . . . . . . . 101 dBA

P - Emission sound

pressure level . . . . . . . . 88 dBA

EMPLOYER'S RESPONSIBILITIES

Employer must enforce compliance with the safety warnings and all other

instructions contained in this manual.

Keep this manual available for use by all people assigned to use this tool.

For personal safety and proper operation of this tool, read and follow all of

these instructions carefully.

OPERATING INSTRUCTIONS

FOREWORD

Porter-Cable Model NS100A is a heavy duty pneumatic stapler. It is designed

to install narrow crown (

" to 1" long), see ACCESSORIES Listing in back of this manual.

CAUTION: Use approved Porter-Cable staples only (see ACCES-

SORIES Listing in back of this manual).

POWER SOURCE

This tool is designed to operate on clean, dry, compressed air at regulated

pressures between 70 and 120 PSI (Pounds per Square Inch). The preferred

system would include a filter, a pressure regulator, and an automatic oiler

located as close to the tool as possible (within 15 feet is ideal).

All compressed air contains moisture and other contaminates that are

detrimental to internal components of the tool. An air line filter will remove most

of these contaminates and significantly prolong the life of the tool. If an in-line

oiler is not available: place five or six drops of Porter-Cable Air Tool Oil (see

ACCESSORIES), into the tool's air inlet at the beginning of each workday.

The tool is equipped with a male "quick connector". The tool must always be

connected to the air supply with a coupling such that all pressure is removed

from the tool when the coupling is disconnected.

CAUTION: All air line components (hoses, connectors, filters,

regulators, etc.) must have a minimum working pressure rating of 150

PSI (10.3 BAR) or 150% of maximum system potential, whichever is

higher.

Do not connect this tool to a system with maximum potential pressure

greater than 200 PSI (13.7 BAR).

Only connect tool to air supply with a coupling that will release all

pressure from the tool when disconnected.

Disconnect tool from air supply before performing maintenance,

clearing a jammed fastener, leaving work area, moving tool to another

location, or handing the tool to another person.