Sbeset.exe - Creative CT4760 Getting Started

SBESET.EXE

See "System Resource
Settings" on page B-3 for a list
of the possible values.
An example of an
SBEMIXER
SBEMIXER /S:64 /W:120 /C:50 /M:0
which corresponds to "set the synth volume to 64, the Wave volume to 120, the CD audio volume
to 50, and turn off the Synth MT-32/LAPC-1 mode".
To set SBEMIXER values within the Mixer screen:
At the DOS prompt, type
SBEMIXER
The interactive editor mode allows you to change the mixer settings with the mouse, <Tab>,
<PgUp>, <PgDn>, or arrow keys.
Use the Save button to save the settings for the next session.
Use SBESET.EXE to manually configure SB resources or disable SB Emulation. By default, SB
Emulation in DOS follows the Windows settings. For example, if you disable SB Emulation in
Windows, in the next boot to DOS, SB Emulation in DOS disabled. Under rare circumstances
you may need to manually reconfigure DOS SB Emulation, for example, if there is conflict in
DOS before it can boot to Windows. SBESET.EXE is run from the command line.
To set SBESET values in the command line:
At the DOS prompt, type the
SBESET [-A xxx ] [-I x ] [-D x ] [-H x ] [-P xxx ] [-d x ] [-w x ]
where square brackets [ ] denote optional parameters, and:
This
Parameter Specifies
-Axxx SB interface's base I/O address.
-Ix IRQ line used by the audio interface.
-Dx First DMA channel used by the audio interface.
-Hx Second DMA channel used by the audio interface.
command is
command in a single line. Its syntax is:
SBESET
SB Emulation in MS-DOS/ Windows 95/98 B-9