Test Run - Hitachi RAI-50PPD Installation And Operation Manual

INSTALLATION OF OPTIONAL AIR PANEL: P-AP56NAMS

12.6 TEST RUN

1 After completing the installation of the air panel, the test run
should be performed.
2 Perform the checking work for the louvre during the test run.
12.7 ADJUSTING LOUVRES
N O T E
• The adequate
conditions (air conditioner's installation position, room structure or
furniture layout, etc.) If the cooling or the heating is not well, adjust
• If the cooling operation is performed under the condition with over
80% humidity, dew condensation may occur at the air panel or the
louvre.
C A U T I O N
Do not move the louvre by hand. If moved, the louvre mechanism will be
damaged. In addition, do not apply an excessive force to the air outlet
part to prevent the breakage.
13 OPTIONAL PART
13.1 OPTIONAL PART CONNECTION FOR INDOOR UNIT
CN11A
To connect to H-LINK, a separately purchased RAC Adapter is required.
To connect to Dry Contact, a separately purchased Dry Contact Connection
Cord is required.
To connect Wired Remote Control, a separately purchased Wired Remote
Control is required.
To connect to WiFi, a separately purchased WiFi Adaptor is required.
● To install the wiring, remove the metal cover of electrical box.
As for Dry Contact, connect the connection cord to CN25.
As for WiFi Adaptor or RAC Adaptor, connect the connection cord to CN1101.
As for Wired Remote Control, connect the connection cord to CN1102.
● The connection cords and power cable are to be arranged and tied up as per
the diagram as shown above.
● Please refer to the respective user manual of the Dry Contact, WiFi Adaptor, RAC
Adaptor and Wired Remote Controller for further details.
● Please refer to user manual for instructions on removal and installation of the
electrical box.
● Please be careful not to damage lead wires by edge of metal plate when connecting
the optional parts.
● For ordering all optional parts, please refer to the catalogue for part number.
26 PMML0477 rev.0 - 07/2017
WIRELESS REMOTE
CONTROLLER CORD
WIFI ADAPTER/
RAC ADAPTOR CORD
CN1101
CN25
CN1101
Do not move the louvre by hand. If moved, the auto-swing
mechanism will be damaged.
Louvre
Louver
WIRED REMOCON CORD
DRY CONTACT CORD