Z-150.6 Sp Input Ends - zapco Z-150.2 SP Owner's Manual

The Z-150.6 SP is the 6-Channel SP amp and it also has the same basic controls and
features as the other amps but has been adapted for 6-channel use.
• The channels 1/2 do not have a low-pass filter as they will be used either full
range or for mids/highs so there is only high pass here
• Ch. 3/4 have high pass, full range, and low pass positions so they can be
used for highs, or they can be band-passed for mid-range use
• Ch. 5/6 do not have a crossover function switch as they are band pass only
They can be used as the bass section with the low-pass and a variable sub
sonic. The sub sonic (which is high-pass), however has a wide frequency range
so it can be used as the bottom of a band-pass to drive mid-bass drivers, if you
have a separate sub amp
• The input mode switch lets you use 2Ch, 4Ch, or 6Ch of input, so you can drive
all the channels from a single 2Ch stereo output from a head unit
1
1• Frequency scale for front and rear
crossovers (Ch 1/2 and 3/4)*
2• Ch1/2 and Ch3/4 RCA inputs
3• Ch1/2 and Ch3/4 variable gain controls
4• Ch1/2 and Ch3/4 HPF frequency controls
5• Ch1/2 and 3/4 crossover mode switches
6• Ch3/4 LPF frequency control
7• Input mode for 2Ch, 4Ch, or 6Ch inputs
* See explanations in Z-150.2P #1

Z-150.6 SP Input Ends

3 5
2 4
13 11 12 14 15
6 7 8
8• Port for optional dash remote
9• Ch 5/6 RCA inputs
10• Frequency scale for Ch5/6 crossovers*
11• Ch5/6 Sub sonic (HP) frequency control
12• Ch5/6 LP bass crossover frequency control
13• Variable bass boost control
14• Ch5/6 variable gain control
15• The power on (green) LED and the protect
(red) LED
9 10
11