Table of Contents
Advertisement
3
Installation
For safety, ensure the mounting surface supports more than the weight of the speaker. Use
only industry-accepted fasteners and mounting methods when mounting the loudspeaker.
Consult an expert if you are unsure.
Caution!
It is the installer's responsibility to determine and use the proper mounting hardware for
!
the wall construction type.
Disregarding this caution could result in damage to the product and personal injuries may
occur.
Installing the subwoofer to a wall
To install the subwoofer to a wall, do the following:
1.
2.
3.
4.
5.
6.
7.
8.
Electro-Voice
Attach the bracket to the wall.
If installing in a corner leave 1.5-inches (40 mm) between the bracket and the ceiling. Use a
minimum of four screws.
Wall
Bracket
Stud
Wire the speaker, as shown in the wiring section.
Remove the two Philip-head screws on the rear of the subwoofer.
Mount one mounting clip to the top of the speaker using the eyebolt (supplied).
Attach the four rubber feet inside the corners on the side of the enclosure that will be
against the wall.
Attach the safety line to the eyebolt in the rear of the subwoofer.
Insert one of the 3/8-16-thread Philips-head screws through the remaining mounting
clip.
Keep this hardware at arm's reach.
Slide the enclosure sideways to engage the top mounting clip over the bracket rung (1).
A: Rungs
A
Installation manual
en
7
2017.08 | 01 | F.01U.347.028
Advertisement
Table of Contents
