Porter-Cable 3802 Instruction Manual page 6

MOVING TABLE TO THE 0 DEGREE CUT-OFF POSITION
1. Rotate locking knob (A) Fig. 6, counter-clockwise as far as it will go to unlock. Depress lever (B) and rotate
table (C) to the 0 degree straight cut-off position, release lever (B) and tighten locking knob (A).
2. Fig. 7, illustrates the table (C) in the 0 degree straight cut-off position.
3. For proper operation and adjustment of the table, refer to sections, "ROTATING TABLE FOR MITER
CUTTING", "ADJUSTING CLAMPING ACTION OF TABLE LOCKING MECHANISM" and "ADJUSTING
SLIDING FIT BETWEEN MOVABLE TABLE AND BASE."
ATTACHING EXTENSION TABLE AND FENCE SLIDE
Fig. 6
B
Fig. 7A
1. Attach flat washers to the two 3/4" screw assemblies (A) Fig. 7A, and thread into the threaded holes on left
side of the saw.
NOTE: Turn the screws only a few threads into the holes at this time.
2. Attach the table extension (B) Figs. 7A and 7B, to left side of saw table, making sure groove of table
extension (B) is inside flat washers (C) as shown in Fig. 7B.
C
B
A
A
B
6 6
C
Fig. 7
C
Fig. 7B