Introduction Congratulations on your purchase of the Extech SD800 CO /Temperature/Humidity Datalogger. This meter measures, displays, and stores CO , temperature and relative humidity readings. Data is stored on a SD card for transfer to a PC. This meter is shipped fully tested and calibrated and, with...
NOTE: To avoid corrupting data, do not remove the memory card without properly ending the record function. Time/Date/Sample Rate Check Press and Hold the TIME button for >2 seconds and the display will cycle through the date, time and sample rate information. SD800-EU-EN- V2.4 1/13...
Page 4
Remove the memory card from the datalogger and plug it into the SD card slot on the PC. Launch Excel® and open the data file on the memory card from within the spreadsheet program. The file will appear similar to the figure below. SD800-EU-EN- V2.4 1/13...
RESET button on the side of the datalogger (use a paper clip or similar pointed object) to return the meter to a working state. RS232 Interface A serial output is provided to link the meter to a PC’s serial port. Call Technical Assistance for more information on this interface. SD800-EU-EN- V2.4 1/13...
Page 6
/ accumulators at collection points in your community or wherever batteries / accumulators are sold! Disposal: Follow the valid legal stipulations in respect of the disposal of the device at the end of its lifecycle SD800-EU-EN- V2.4 1/13...
Need help?
Do you have a question about the SD800 and is the answer not in the manual?
Questions and answers