Delta 28-248 Instruction Manual page 16

ON / OFF SWITCH
TO STAND
1. Remove the two outer hex nuts and lock washers (A)
Fig. 34 from the two screws extending out from the back
of the switch box (B).
2. Insert two screws (C) Fig. 35, located on back of
switch box, into two holes (D) located in the band saw
arm.
3. Use the two nuts and lockwashers (L) Fig. 36,
removed in STEP 1, to fasten the switch box to the
bandsaw arm.
4. Remove the screw and cable clamp (E) Fig. 37 from
the lower arm of the band saw.
5. Insert the switch cord and power cord (F) Fig. 37
into the clamp (E) (removed in STEP 4), and fasten to the
bandsaw.
6. Insert the cord bushing into hole (G) Fig. 38, on the
top of the band saw stand.
F
E
Fig. 37
B
A
A
D
L
16
Fig. 34
C
Fig. 35
Fig. 36
G
Fig. 38