Wrench Storage; Carrying Handle - Porter-Cable 1400 Instruction Manual

ADJUSTING DOWNWARD
TRAVEL OF ABRASIVE
WHEEL
A stop screw (A) Fig. 12, is provided to limit the
downward travel of the abrasive wheel. This adjustment
is made by loosening lock nut (B) and turning stop screw
(A) in or out as desired. Then tighten lock nut (B).
Fig. 13 illustrates edge of the arm casting (C) contacting
stop screw (A) limiting the downward travel of the
abrasive wheel. NOTE: As the abrasive wheel becomes
smaller in diameter, because of wear, the downward
travel of the wheel can be increased. When the blade is
changed, the stop screw (A) Fig. 12 will need to be re-
adusted to limit the downward travel of the wheel.

WRENCH STORAGE

A slot (A) Fig.14, is provided on the back of the machine
base for convenient storage of the adjusting wrench (B),
which is supplied with your machine. Fig. 14 illustrates
the wrench (B) stored in position in the slot.

CARRYING HANDLE

When transporting the machine, the cutting head should
always be locked in the down position by means of the
hold down chain (A) Fig. 15. A carrying handle (B) is
provided for ease of transportation.
C
8
A
B
Fig. 12
A
Fig. 13
A
B
Fig. 14
B
A
Fig. 15