Accessories Supplied; Manufacturer Recommendations; Safety Warning - Wavecom TnT ELB G4-Series User Manual

Wavecom Instruments Portable Appliance Testers Instruction Manual

Accessories Supplied


Portable Appliance Tester Instruction Manual

Manufacturer's 1

IEC test lead (500mm orange/red)

Earth Lead with Alligator Clip (1800mm black)

Soft Carry Case

Locking IEC Power Cable (1800mm Blue)

*Battery model (power bank)

*
Battery model USB lead
Precautions

Manufacturer Recommendations

:
Calibration
The manufacturer recommends a routine calibration / verification of this unit to ensure the accuracy
of readings on a 12 monthly basis, or as prescribed under any additional local Regulatory requirements.
Note: Only Wavecom Instruments or its Authorised Service Agents are permitted to repair and Calibrate this
Instrument. Failure to perform unauthorised service or repair may void all warranties and Calibration Status.
TnT Firmware & TnT G4 series in general have the ability to be updated to comply with potential Changes in
Testing Standards

Safety Warning

th
This 4 Generation TnT series of products have been designed to meet stringent safety
requirements, however no device can completely protect persons from the consequences of incorrect use.
The testing of Electrical appliances requires that extra care and caution is taken at all times to ensure personal
safety.
The Manufacturer also advises that appliance testing should be conducted by a Competent and suitably trained
person, as referred to under the current Standard AS3760:2010, as well as any additional legislation or rulings in
different states.
If in doubt, the manufacturer suggests the user contact their responsible Authority.
For maximum safety, always ensure that the following advice is followed:

The equipment being tested is in good repair

All user instructions are followed.

Double check power supply connections. (note LED status)

Always use specified fuses and protection devices.

Do not use leads that require repair or are damaged.

If you are unsure, call a licensed Engineer/Electrician
Important Information
Calibration Certificate – (Valid for 12 months)
st
Unique Locking Power Cable
Please make sure yellow lever is pressed prior to removal of
the locking power supply cable. Though the case of the G4
TnT is manufactured from impact resistant & flame retardant
ABS, failure to do so, combined with excessive force may
damage the rear panel.
Switch from battery power to mains power
To switch from battery power to mains power, simply plug in
the supplied blue power cord. There is no need to disconnect
the battery cable. However, it is advised to disconnect the
USB AM-BM cable from USB B port from the rear of unit.
In case of switching from mains power to power bank
or switching off the unit using Enter button, disconnect
the USB cable from USB B port of unit and connect it
back, press the Enter button to start the unit.
.
. * See P.5 AS/NZ 3760:2010 def.
3