Meter Mode - Wavecom TnT ELB G4-Series User Manual

Wavecom Instruments Portable Appliance Testers Instruction Manual
Note 2: Leakage test may be performed if for any reason a standard CLASS 1 or CLASS 2 is not possible.
Meter Mode®

Load Current: 0.0 to 10Amp

Voltage: 200 to 265VAC

Apparent Power: 0 to 2400VA

Power: 0 to 2400W
TnT Features
Meter Mode ®
Meter Mode Screen
How to Activate Meter Mode

Hold F3 from main screen display for 2 seconds
Main Menu A

Screen will change to show volts by default when socket is ( not powered )

Plug appliance into testers , test socket , Press F3 to go into power mode and will show

(Warning device will be powered)

Press F3 again to continue and
green and device will power up. Otherwise press enter to exit.
Warning Screen

Press the enter key to stop the power mode and return to volts.

Pressing F3 key will start power mode again.

TnT stays in Meter Mode regardless of power on/off until you exit

Pressing Return key

If the TnT is reset in meter mode it will return to meter mode when powered up again.
Meter Mode Uses
Meter Mode is a new and versatile function of the new Gen 4 tester that will allow you to display
Electrical Parameters from a Power outlet source or from the appliance under test.
Typical Applications
Example.: Measuring the Power of a bar heater, or electric power drill check the ratings and compare them to that
on the compliance plate etc. Quick test of Power outlet Voltages in rooms or locations split from multiple circuits.
Meter Mode Features – (Four Discrete Options)
Volts Screen
(power the device). If you continue the A-N LED on the tester will flash
Amps Screen
will exit meter mode and return the main menu.
(Not Available In Battery Mode)
Watts Screen Volts/Amps Screen
17