Mitsubishi Electric MELSEC iQ-F FX5 Reference page 23

Item Description
Restrictions or precautions • This FB does not include the error recovery processing. Program the error recovery processing separately in accordance
with the required system operation.
• This FB cannot be used in an interrupt program.
• Using the FB in a program that is to be executed only once, such as a subroutine program or a FOR-NEXT loop, has a
problem that i_bEN (execution command) can no longer be turned off and normal operation is not possible; Always use the
FB in a program that is capable of turning off the execution command.
• To use more than one of this FB, care must be taken to avoid duplication of the target channel.
• The FB requires the configuration of the ladder for every input label.
• When operating the analog output module, the output range setting needs to be set according to the device and system to
be connected. Set the GX Works3 module parameters according to the application. Refer to the MELSEC iQ-F FX5
User's Manual (Analog Control - Intelligent function module) for details on setting the module parameters.
Error code
Error code Description
(hexadecimal)
100 The target channel is set out of the range.
Set the target channel within the following range.
• FX5-4DA: 1 to 4, 15
102 The module type is set out of the range.
Set the module type to the following values.
• FX5-4DA: 0
Action
Review and correct the settings and then execute the FB
again.
Review and correct the settings and then execute the FB
again.
3 ANALOG OUTPUT MODULE FB
3.4 M+FX5-4DA_WaveOutputReqSetting
3
21