Subaru Legacy 2003 Service Manual page 33

(4) Tighten throttle position sensor holding
screws.
Tightening torque:
1.6 N·m (0.16 kgf-m, 1.2 ft-lb)
4) When using Subaru Select Monitor;
(1) Turn ignition switch to OFF.
(2) Loosen throttle position sensor holding
screws.
NOTE:
For detailed operation procedures, refer to the
Subaru Select Monitor Operation Manual.
(3) Insert the cartridge to Subaru Select Moni-
tor.
<Ref. to FU(H4SOw/oOBD)-12, PREPARA-
TION TOOL, General Description.>
(4) Connect Subaru Select Monitor to the data
link connector (A).
5) Turn ignition switch to ON, and Subaru Select
Monitor switch to ON.
6) Select {2. Each System Check} in Main Menu.
THROTTLE POSITION SENSOR
FU-00741
FU-00741
( A )
FU-00435
FU(H4SOw/oOBD)-31
FUEL INJECTION (FUEL SYSTEMS)
7) Select {Engine Control System} in Selection
Menu.
8) Select {1. Current Data Display & Save} in En-
gine Control System Diagnosis.
9) Select {1.12 Data Display} in Data Display
Menu.
10) Adjust throttle position sensor to the proper po-
sition to match with the following specifications.
Condition: Throttle fully closed
Throttle opening angle 0.00%
Throttle sensor voltage 0.50 V
11) Tighten throttle position sensor holding screws.
Tightening torque:
1.6 N·m (0.16 kgf-m, 1.2 ft-lb)
FU-00741