Subaru Legacy 2003 Service Manual page 26

FUEL INJECTION (FUEL SYSTEMS)
9) Tighten bolt which install injector pipe on intake
manifold.
Tightening torque:
5.0 N·m (0.51 kgf-m, 3.7 ft-lb)
10) Install purge control solenoid valve.
11) Connect hoses to purge control solenoid valve.
NOTE:
Connect evaporation hoses as shown in the figure.
A
(A) To fuel pipe
(B) To intake manifold
12) Install engine harness onto intake manifold.
Tightening torque:
16 N·m (1.6 kgf-m, 12 ft-lb)
13) Connect connectors to fuel injectors and purge
control solenoid valve.
INTAKE MANIFOLD
14) Hold engine harness by harness band (A) and
harness bracket (B).
NOTE:
Do not use harness band on harnesses where they
FU-00731
are supposed to be protected by the fuel pipe pro-
tector.
15) Install intake manifold protector RH.
Tightening torque:
FU-00730
16) Install intake manifold protector LH.
Tightening torque:
B
FU-00285
FU(H4SOw/oOBD)-24
( A )
( B )
19 N·m (1.9 kgf-m, 13.7 ft-lb)
19 N·m (1.9 kgf-m, 13.7 ft-lb)
( A )
FU-00795
FU-00726
FU-00266