3. Walk through the coverage area noting where
you are when the lights turn on. In TEST mode,
light will stay on for 5 seconds after sensing
motion and then turn off.
4. Adjust the SENSITIVITY to increase or
decrease the range as needed. Too much sen-
sitivity may cause false triggering due to heat
sources in the coverage area (see Adjustment of
Coverage Area or Troubleshooting section).
5. Set the amount of ON-TIME you want the
light to stay on after motion is detected (1, 5,
or 10 minutes).
6 ft.
(1.8 m)
30 ft.
(9.1 m)
Maximum Range
The sensor is less sensitive to motion directly
towards it and more sensitive to motion across
coverage area.
Motion
Least Sensitive
Maximum
Coverage Angle*
(Top View)
Motion
Sensor
Most Sensitive
Mode:
Test
5 Seconds
Auto
Manual
To Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
for the circuitry to calibrate.
Manual mode only works at
night because daylight returns
150°
the sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.
6
OPERATION
On-Time
Works: Day Night
1, 5, or 10
Minutes
MANUAL MODE
x
x
x
x
/
minutes
1
2
1 Second
OFF then...
... back on.
206873-02