Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
WARNING: Turn power off at circuit
breaker or fuse. Place tape over circuit
breaker switch and verify power is off at
the fixture.
For best performance, mount the fixture about 6
feet (1.8 m) above the ground.
1. Remove two decorative nuts.
2. Remove mounting plate.
3. Tighten mounting screws finger tight.
4. Attach mounting plate to junction box.
Decorative Nut
Wire Path
Bracket
Mounting
Screw
Note: We recommend having an assistant help hold
the lantern assembly during the wiring process.
This fixture comes with a universal mounting
bracket. It is pre-assembled on the fixture to fit
the majority of junction box applications.
However, if the slots on the mounting plate do not
line up with the junction box screw holes:
1. Remove the fixture mounting screws from
2. Attach ground wire "pigtail" to ground screw on
3. Flip the mounting plate over.
4. Rotate the mounting plate so the wire path
5. Reinstall the fixture mounting screws and at-
Mounting
Plate
Wire Path
Mounting Screw
Ground Screw
Junction
Box
Mounting
Plate
2
the mounting plate. Note: Do not remove the
ground screw.
mounting plate (See Recommended Ground-
ing Method for additional information).
is on the upper right. Note: The wire path on
the mounting plate must be located as shown
below to allow the wires on the back of the
fixture to pass through.
tach the mounting plate to the junction box
as shown.
Ground Screw
Fixture Screws
As Shipped
Wire Path
Flipped and
Rotated
206873-02
Advertisement
Table of Contents
