Bluetooth Mode - Uconnect 6.5 NAV Owner's Manual Supplement

Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you insert an Auxiliary device with the ignition
ON and the radio ON, the unit will switch to AUX mode
and begin to play when you insert the device cable.
Controlling The Auxiliary Device
The control of the auxiliary device (e.g., selecting play-
lists, play, fast forward, etc.) cannot be provided by the
radio; use the device controls instead. Adjust the volume
with the VOLUME/MUTE rotary knob, or with the
volume of the attached device.
NOTE: The vehicle radio unit is acting as the amplifier
for audio output from the Auxiliary device. Therefore if
the volume control on the Auxiliary device is set too low,
there will be insufficient audio signal for the radio unit to
play the music on the device.
Source
Press the "Select Source" button to select the desired
audio source, USB/iPod, SD Card, AUX or Bluetooth.
This screen will time out after a few seconds and return
to the main radio screen if no selection is made.
Audio
Refer to Radio Mode for adjusting the audio settings.

Bluetooth Mode

Overview
Bluetooth Streaming Audio (BTSA) or Bluetooth Mode is
entered by pairing a Bluetooth device, containing music,
to the Uconnect System.
Before proceeding, the Bluetooth device must be paired
to the Uconnect Phone to communicate with the
Uconnect System.
MEDIA MODE 51
5