Table of Contents
Advertisement
7.2 NORMAL OPERATION WITH MULTIPLE REMOTE CONTROLLER INSTALLED
● Press the ON/OFF button. Then the Power light is lit on the remote controller and the setting
temperature is displayed on each remote controller.
● Set the temperature as you require (the tempreature setting can be change only by the priority unit).
If you desire to transfer the priority setting, you can transfer it by pressing ON/OFF button.)
● Open a hot water tap, and ensure the Burning light is ON. Mix cold water with the hot if you
need.
● Close the hot water tap, and the Burning light is OFF.
When the remote controller used on EN20CF-LP70 & EN20CF-NG70 model, it is able to
adjust the setting temperature in the range of 38
!
Water temperatures above 50 ºC can cause severe burns or death from scalding. Children,
the disabled and the elderly are at a high risk of being injured. Feel the water temperature
before bathing or showering. Do not leave children, disabled persons, or the elderly
unsupervised. The Australian Standards AS 3498 gives full details of the requirements for
supply of controlled temperature to ablution outlets (bathrooms) and is required to be
conformed to under all plumbing codes within Australia.
ON/OFF
Reduce
button
temperature
button
NOTE
WARNING
19
Increase
temperature
button
to 65
ºC
ºC.
Advertisement
Table of Contents
