Connection Of Remote Controller Wiring To The Water Heater - Prevail-Catv EN Series Installation Manual & Operation Manual

5.2 CONNECTION OF REMOTE CONTROLLER WIRING TO THE WATER HEATER

① Turn off the power supply to the water heater.
② Remove the front cover from the water heater. There are 4 screws on the front cover.
③ Put the remote wires through the hole on the bottom of the unit case.
④
Connect remote control wires to remote terminals directly.
●
DO NOT jump or short-circuit wires otherwise PCB may be damaged.
⑤ Put back the front cover and connect the power plug.
Put the remote wires though the
hole on the bottom of the case.
Power
Flashing Priority
Water temperature adjustment
COOL
HEAT
ON/ OFF
Remote controller terminal
Burning Power
Flashing Priority
°
C
TYPICAL CABLE LAYOUT
ON SAB
1 2 3 4
Burning
°
C
Water temperature adjustment
COOL
HEAT
ON/ OFF
16
Power Burning
Flashing Priority
°
C
Water temperature adjustment
COOL
HEAT
ON/ OFF